Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - MULTICAST ROUTING CONFIGURATION GUIDE 2010-10-07 Configuration Manual page 59

show ip multicast protocols brief
Copyright © 2010, Juniper Networks, Inc.
Blocked <S,G> count—Number of blocked S,G data streams on the interface
Example
host1#show ip multicast protocols
Multicast protocols:
Protocol Pim
Type: Sparse
Interfaces: 1 registered, 1 owned
Registered interfaces:
ATM2/1.103 (103.0.0.2/24) owner Pim
Protocol Igmp
Type: Local
Interfaces: 1000 registered, 1000 owned
Registered interfaces:
ATM2/0.131 (13.0.0.1/24) local Igmp owner Igmp
Admission-bandwidth 2000000/10000000 bps
QoS Adjust 2000000 bps
Active <S,G> count
Blocked <S,G> count
ATM2/0.132 (13.0.0.2/24) local Igmp owner Igmp
Admission-bandwidth 0/10000000 bps
QoS Adjust 0 bps
Active <S,G> count
Blocked <S,G> count
ATM2/0.133 (13.0.0.3/24) local Igmp owner Igmp
Admission-bandwidth 8000000/10000000 bps
QoS Adjust 0 bps
...
Count: 2 protocols
See show ip multicast protocols.
Use to display a summary of information about multicast protocols enabled on the
router.
Field descriptions
Protocol—Name of the multicast protocol
Registered Interfaces—Number of interfaces on which the protocol is configured
Owned Interfaces—Number of interfaces that a protocol owns. If you configure only
IGMP on an interface, IGMP owns the interface. However, if you configure IGMP and
either PIM or DVMRP on the same interface, PIM or DVMRP owns the interface.
Type—Mode of the multicast protocol
For DVMRP—Dense
For PIM—Sparse, dense, or sparse-dense
Chapter 1: Configuring IPv4 Multicast
15
10
25
10
37