Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
•
There are no user guidelines for this command.
Example
The following example configures the mrouter timeout to 200 seconds.
Console (config)# interface vlan 2
Console (config-if)# ip igmp snooping mrouter-time-out 200
ip igmp snooping leave-time-out
The ip igmp snooping leave-time-out VLAN Interface Configuration mode command configures the
leave-time-out. If an IGMP report for a Multicast group is not received within the leave-time-out period
after an IGMP leave was received from a specific port, the current port is deleted from the member list of
that Multicast group. Use the no form of this command to configure the default leave-time-out.
Syntax
•
ip igmp snooping leave-time-out {time-out | immediate-leave}
•
no ip igmp snooping leave-time-out
•
time-out — leave-time-out in seconds. (Range: 0 - 2147483647)
•
immediate-leave — Specifies that the port should be immediately removed from the members list
after receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
•
The leave timeout should be set greater than the maximum time that a host is allowed to respond to
an IGMP Query.
•
Use immediate leave only where there is only one host connected to a port.
198
IGMP Snooping Commands