Figure 6-16. Add Sntp Interface - Dell PowerConnect 3424 User Manual

Figure 6-16. Add SNTP Interface

3
Define the relevant fields.
4
Click Apply Changes.
The SNTP interface is added, and the device is updated.
Defining SNTP Interface Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
SNTP Interface Settings page.
NOTE:
An IP address must be defined on the interface in order to define it as an Anycast or
Broadcast interface.
Table 6-23. SNTP Interface Settings CLI Commands
CLI Command
sntp client enable
show sntp configuration
The following is an example of the CLI commands for displaying SNTP interfaces:
console# show sntp configuration
Polling interval: 7200 seconds.
MD5 Authentication keys: 8, 9
Authentication is required for synchronization.
Trusted Keys: 8,9
Unicast Clients Polling: Enabled.
Description
Enables the Simple Network Time Protocol
(SNTP) client on an interface.
Shows the configuration of the Simple Network
Time Protocol (SNTP).
Configuring System Information
121