Dell PowerConnect 3424 User Manual page 261

• Only one destination port can be defined.
The following restrictions apply to ports configured to be source ports:
• Source Ports cannot be a LAG member.
• Ports cannot be configured as a destination port.
• Up to 8 source ports are supported.
To open the Port Mirroring page, click Switch → Ports → Port Mirroring in the tree view.
NOTE:
When a port is set to be a target port for a port-mirroring session, all normal operations on it
are suspended. This includes Spanning Tree and LACP.
Figure 7-18. Port Mirroring
The Port Mirroring page contains the following fields:
Destination Port — The port number to which port traffic is copied.
Transmit Packets — Defines the how the packets are mirrored. The possible field values are:
Untagged — Mirrors packets as untagged vlan packets. This is the default value.
Tagged — Mirrors packets as tagged vlan packets.
Type — Indicates if the mirrored packets are RX, TX, or both RX and TX.
Status — Indicates if the port is currently monitored (Active) or not monitored (Ready).
Remove — When selected, removes the port mirroring session.
Configuring Switch Information
261