Dell PowerConnect 3424 User Manual page 271

GARP Leave Timer (10 - 2147483640) (Msec)— Time lapse, in milliseconds, that the device waits
before leaving its GARP state. Leave time is activated by a Leave All Time message sent/received,
and cancelled by the Join message received. Leave time must be greater than or equal to three
times the join time. The default value is 600 msec.
GARP Leave All Timer (10 - 2147483640) (Msec) — Time lapse, in milliseconds, that all devices
wait before leaving the GARP state. The leave all time must be greater than the leave time
The default value is 10000 msec.
Defining GARP Timers
1
Open the GARP Timers page.
2
Select an interface.
3
Complete the fields.
4
Click Apply Changes.
The GARP parameters are saved to the device.
Copying Parameters in the GARP Timers Table
1
Open the GARP Timers page.
2
Click Show All.
The GARP Timers Table opens.
3
Select the interface type in the Copy Parameters from field.
4
Select an interface in either the Port or LAG drop-down menu.
The definitions for this interface are copied to the selected interfaces. See step 6.
5
Select the Copy to check box to define the interfaces to which the GARP timer definitions
are copied, or click Select All to copy the definitions to all ports or LAGs.
6
Click Apply Changes.
The parameters are copied to the selected ports or LAGs in the GARP Timers Table, and the
device is updated.
.
Configuring Switch Information
271