Dell PowerConnect 3424 User Manual page 272

Defining GARP Timers Using CLI Commands
This table summarizes the equivalent CLI commands for defining GARP timers as displayed in the
GARP Timers page.
Table 7-73. GARP Timer CLI Commands
CLI Command
garp timer {join | leave | leaveall}
timer_value
The following is an example of the CLI commands:
console(config)# interface ethernet 1/e1
console(config-if)# garp timer leave 900
console(config-if)# end
console# show gvrp configuration ethernet 1/e11
GVRP Feature is currently Disabled on the device.
Maximum VLANs: 223
Port(s) GVRP-
Status
------- --------
1/e11 Disabled
272
Configuring Switch Information
Description
Adjusts the GARP application join, leave,
and leaveall GARP timer values.
Registration Dynamic VLAN
Creation
------------ ------------
Normal Enabled
Timers (milliseconds)
Join Leave
------- ------
200 900
Leave All
---------
10000