Dell PowerConnect 3424 User Manual page 72

01-Jan-2000 01:01:19 %Entity-I-SEND-ENT-CONF-CHANGE-TRAP: entity
configuration change trap.
01-Jan-2000 01:01:19 %Box-I-FAN-STAT-CHNG: FAN# 2 status changed -
operational.
01-Jan-2000 01:01:19 %Box-I-PS-STAT-CHNG: PS# 1 status changed -
operational.
2
When using the HyperTerminal, click Transfer on the HyperTerminal Menu Bar.
3
In the Filename field, enter the file path for the file to be downloaded.
4
Ensure that the Xmodem protocol is selected in the Protocol field.
5
Press Send. The software is downloaded.
NOTE:
After software download, the device reboots automatically.
Erase FLASH File - option[2]
In some cases, the device configuration must be erased. If the configuration is erased, all
parameters configured via CLI, EWS or SNMP must be reconfigured.
To erase the device configuration:
1
From the Startup menu, press [2] within two seconds to erase flash file. The following
message is displayed:
Warning! About to erase a Flash file.
Are you sure (Y/N)? y
2
Press Y . The following message is displayed.
Write Flash file name (Up to 8 characters, Enter for none.):config
File config (if present) will be erased after system
initialization
======== Press Enter To Continue ========
3
Enter config as the name of the flash file. The configuration is erased and the
device reboots.
4
Repeat the device initial configuration.
Password Recovery - option[3]
If a password is lost, the Password Recovery procedure can be called from the Startup menu. The
procedure enables entry to the device once without password.
72
Configuring PowerConnect 3424/P and 3448/P