Dell PowerConnect 3424 User Manual page 266

Configuring Static Address Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring static address
parameters as displayed in the Static MAC Address Table page.
Table 7-71. Static Address CLI Commands
CLI Command
bridge address mac-address [permanent
| delete-on-reset | delete-on-timeout |
secure] {ethernet interface | port-
channel port-channel-number}
show bridge address-table [vlan vlan]
[ethernet interface | port-channel port-
channel-number]
The following is an example of the CLI commands.
console(config-if)#bridge address 00:60:70:4C:73:FF permanent
ethernet g8
console# show bridge address-table
Aging time is 300 sec
vlan
----
1
1
200
266
Configuring Switch Information
Description
Adds a static MAC-layer station source
address to the bridge table.
Displays entries in the bridge-forwarding
database.
mac address
------------
00:60:70:4C:73:FF
00:60:70:8C:73:FF
00:10:0D:48:37:FF
port type
---- --------
1/e8 dynamic
1/e8 dynamic
1/e9 static