Enabling Multiple Hosts Using the CLI Commands
The following table summarizes the equivalent CLI commands for enabling the advanced port
based authentication as displayed in the Multiple Hosts page.
Table 7-62. Multiple Hosts CLI Commands
CLI Command
dot1x multiple-hosts
dot1x single-host-violation
{forward |discard
|discard-shutdown}[trap
second s]
The following is an example of the CLI Command.
Console(config)# interface ethernet 1/e1
Console(config-if)# dot1x multiple-hosts
234
Configuring Switch Information
Description
Allows multiple hosts (clients) on an 802.1X-
authorized port that has the dot1x port-control
interface configuration command set to auto.
Configures the action to be taken when a station,
whose MAC address is not the client (supplicant)
MAC address, attempts to access the interface.