Cli Examples; Example #1: Enable Routing For The Switch - NETGEAR 7000 Series Administration Manual

• To prevent any RIP packets from being transmitted

CLI Examples

The configuration commands used in the following example enable RIP on ports 1/0/2 and 1/0/3 as
shown in the network illustrated in
Figure 7-4

Example #1: Enable Routing for the Switch

The following sequence enables routing for the switch:
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit
IP Routing Services
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.2
Figure 7-4
v1.0, May 2008
7-13