Setting With The Printer Operation Panel - Canon imagePROGRAF W6400 User Manual

TCP/IP Network Settings (Windows, Macintosh, UNIX)
3
Execute the following commands to set the
IP address for the printer.
ping <IP Address> -l 479
IP address:
Specify the same IP address used in
Entry Sample:
ping XXX.XXX.XXX.XXX -l 479
(For Windows)
ping –s 479 XXX.XXX.XXX.XXX
(For Red Hat Linux)
ping –s XXX.XXX.XXX.XXX 479
(For Solarius)
Note
The "l" of the "-l" entry is an alphabetic lower case "l"
(el).
The subnet mask and gateway address are set to
"0.0.0.0".
After completing the above settings, use the Remote
UI or the printer operation panel to perform the subnet
mask and gateway address settings for your network.
(→ P.5-12, P.5-15)
This completes the preparation for printer protocol set-
tings.
5- 12

Setting with the Printer Operation Panel

The network information can be set up on the printer
operation panel. Enter the settings for the IP address,
subnet mask, and default gateway.
1
Step 2.
Press the Online button to display MAIN
MENU.
2
Press [
then press [
MAIN MENU
Set Interface
3
Press [
press [
Interface Set
TCP/IP
4
Press [
press [
TCP/IP
IP Setting
MAIN MENU
Head Cleaning
Cleaning
(3 sec.)
Stop/Eject
(1 sec.) Online
] or [ ] to select Interface Setup
].
↓
] or [ ] to select TCP/IP, then
].
↓
] or [ ] to select IP Setting, then
].
↓
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index