Canon imagePROGRAF W6400 User Manual page 295

TCP/IP Network Settings (Windows, Macintosh, UNIX)
13
Press [ ] once then press [
select Default G/W then press [
IP Setting
Default G/W
14
Press [ ] or [
setting of the default subnet mask, then
press OK button.
Default G/W
=0.0.0.0
15
To enter the default gateway IP address,
press [ ] or [
change, then press OK button.
The selected digit increments by 1 every time you
press [ ]. However, at 255 the number rolls up to 0.
The selected digit decrements by 1 every time you
press [ ]. However, at 0 the number rolls up to 255.
Default G/W
=XXX.0.0.0
16
Repeat Steps 14
gateway IP address.
Now you are ready to register the IP address, subnet
mask, and default gateway setting.
17
Press the [ ] button 3 times.
Default G/W
=XXX.XXX.XXX.XXX
Store Setting is displayed.
5- 14
] or [ ] to
].
↓
] to change the number
] to select the number to
to 15 to enter the default
18
Press the OK button.
If you want to cancel the setting, press Stop button
for at least 1 second.
Store Setting
OK?
The printer restarts after Storing appears on the
display.
When you are finished with the settings, the printer
returns Online.
If an error occurs, check the settings then set them
again.
Important
If you need to change the IP address, subnet mask, or
default gateway, you must perform
the setting. If the setting is not registered, the entered
value will not be enabled.
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Step 18 to register
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
TOP
Index