Selecting The Paper Source; Loading Roll Media - Canon imagePROGRAF W6400 User Manual

Printing with Rolls
Printing with Rolls

Loading Roll Media

This is the general procedure for loading roll media.
After printing, remove the completed printout and any
media loaded on the platen. (→ P.2-33, P.2-39)
On the operation panel, select the roll media source.
(→ P.2-26)
Load the roll media in the roll holder slot. (→ P.2-27)
Load the roll media on the platen. (→ P.2-30)
On the printer operation panel, select the media type.
(→ P.2-30)
Adjust the amount of media feed. (→ P.4-42)
Start the print job from the computer. (→ P.1-40)
Important
Make sure that the printer is switched on before you
load roll media. If the loaded media does not match the
media type, this can affect the quality of printing.
2- 26

Selecting the Paper Source

When printing on roll media, select roll media as the
paper source on the operation panel.
1
Press and hold the Paper Source button for
1 second or more to light the Roll Media
lamp.
Pressing the Paper Source button alternates the
selection between Roll Media and Cut Sheet.
Information Power
Data
Offline
Feed Papre
Message
Cleaning
(3 sec.)
Stop/Eject
(1 sec.) Online
Offline
Menu
When a cut sheet is loaded, the printer will display
Remove CutSheet?.
When another roll media is loaded, hold down the
Stop button for more than 1 sec., to display Remove
RllMedia?.
2
If either a cut sheet or roll media is loaded in
the printer, press the OK button.
Remove RllMedia?
Press OK/Stop
Remove either the cut sheet or the roll media.
(→ P.2-33, P.2-39)
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index