Canon imagePROGRAF W6400 User Manual page 96

Printing with Rolls
If the printer cannot perform automatic cutting with
the media:
1. Press the Online button to set the printer
offline.
2. Press the [ ] button (not longer than 0.8 sec)
to feed the media 330 mm.
3. Cut along the cutting-line with a pair of scissors.
4. Hold down the [ ] button on the printer
operation panel for more than 1 sec. until you
see Feed Limit.. on the display. The roll media
reverse feeds 300 mm and stops automatically.
5. Press the Online button to set the printer
offline.
Important
If the printer receives new print data before this
operation is performed, printing will continue.
Cut exactly along the cut-line. The printer may not be
able to perform continuous printing if you cut at a
position more than 30 mm away from the cut-line.
2- 34
For Heavyweight Glossy Photo Paper,
Heavyweight SemiGlossy Photo Paper, Backlit
Film, CAD Translucent Matte Film:
The printer stops after printing to protect the
printing surface. To prevent the printouts from
falling into the output stacker, support the printout
with your hand and press the Stop/Eject button to
perform the cut.
Important
If the ink drying time has been set, you will not be able
to perform cutting with the Stop/Eject button until the
prescribed drying time has elapsed.
3
Rotate the roll holder backward to take up
excess media and remove it.
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index