Canon imagePROGRAF W6400 User Manual page 29

Function Menus
Menu Item
Store Setting
Init. Settings
Maintenance
Replace P.head
Move Printer
System Setup
Warning
Buzzer
Head Ht. Wrning
Med.type Wrning
Change Cutter
1- 26
Setting Values
OK?
OK?
No, Yes
No, Yes
On*, Off
On*, Off, Check Head Hght
On*, Off
No, Yes
Function
Resets all of the Interface Setup settings to
their factory defaults.
Sets the printer in the replace printhead
mode. This menu is not displayed while the
maintenance cartridge capacity warning is
displayed. (→ P.4-23)
Sets the printer to the mode that enables you
to carry out the procedures required before
transporting the printer to another location.
This menu is not displayed while the
maintenance cartridge capacity warning is
displayed. (→ P.4-32)
Sets the buzzer function. When set to On,
the buzzer sounds when an error occurs.
Determines whether a prompt is issued
when the printhead is not at the correct
height for the print media.
Determines whether a warning is issued
when the media loaded in the printer does
not match the media specified for the print
job.
Prepares the printer so the cutter can be
replaced when replacement is necessary.
After replacement, you can reset the number
of cuts.
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index