Canon imagePROGRAF W6400 User Manual page 26

Function Menus
Menu Item
Standard Adj.
Auto Print
Feed Priority
Adjust Band
Standard Adj.
Advanced Adj.
Fine Tuning
Adjust Length
1- 23
Setting Values
No, Yes
On*, Off
Band Joint*, Print Length
No, Yes
No, Yes
-3 ~ 0* ~ +3
-0.70 ~ 0.00* ~ 0.70%
Function
Prints the adjustment pattern used to adjust
the position of the printhead, reads the
results of the pattern, and then automatically
adjusts the values for printhead positioning.
You can set Advanced Adj. to print
automatically immediately after the printhead
is replaced.
Sets the priority for the precision of media
feed. Select Print Length when you want
the media to feed accurately. When Print
Length is selected, color may blur slightly in
the direction of carriage scanning.
Adjusts the amount of line feed for each type
of media. (→ P.4-42)
The printer prints this pattern and uses it to
adjust the amount of feed; it scans the
printout and automatically adjusts the values
for each type of media.
Use with media other than Canon media or
media not approved for output with the
printer. The adjustment value is set
automatically when the printer reads the
printed pattern. However, this requires more
time than Standard Adj. and consumes
more ink.
Allows manual entry of a value to fine adjust
the band adjustment of the media selected
for printing.
Adjusts the amount of stretching and
shrinking for each media type. To set a
longer feed for a media that stretches easily,
adjust the value to the plus (+) side, or adjust
it to the minus (-) side to set a shorter feed
for a media that shrinks easily. This menu is
displayed only when Print Length is
selected for Feed Priority.
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index