Canon imagePROGRAF W6400 User Manual page 294

TCP/IP Network Settings (Windows, Macintosh, UNIX)
5
Press [ ] or [
press [ ].
IP Setting
IP Address
6
Press [ ] or [
setting of the IP address, then press the OK
button.
IP Address
=0.0.0.0
7
To enter the IP address allocated for the
printer, press [
number, then press [
The selected digit increments by 1 every time you
press [ ]. However, at 255 the number rolls up to 0.
The selected digit decrements by 1 every time you
press [ ]. However, at 0 the number rolls up to 255.
IP Address
=XXX.0.0.0
Note
If you press and hold the [
increases or decreases in steps of 10
8
Repeat Steps 6
assigned to the printer.
IP Address
=XXX.XXX.XXX.XXX
Enter the subnet mask.
5- 13
] to select IP Address, then
↓
] to change the number
] or [ ] to change the
] or the OK button.
] or [ ] button, the value
to 7 to enter the IP address
9
Press [ ] once then press [
select Subnet Mask then press [
IP Setting
↓
Subnet Mask
10
Press [ ] or [ ] to change the number
setting of the subnet mask, then press OK
button.
Subnet Mask
=0.0.0.0
11
Press [ ] or [ ] to set the number of the
subnet mask in use on the network, then
press OK button.
The selected digit increments by 1 every time you
press [ ]. However, at 255 the number rolls up to 0.
The selected digit decrements by 1 every time you
press [ ]. However, at 0 the number rolls up to 255.
Subnet Mask
=XXX.0.0.0
12
Repeat Steps 10 to 11
mask that the network is using.
Subnet Mask
=255.255.255.0
Enter the default gateway.
] or [ ] to
].
to enter the subnet
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index