Table of Contents
Advertisement
3
Execute the following commands to set the IP address in the network
interface board.
For Windows:
ping <IP address> -l 479
For Solaris 1.x/2.x:
ping -s <IP address> 479
For IBM-AIX:
ping <IP address> 479
For HP-UX:
ping <IP address> 487
For Red Hat Linux/LASER5 Linux:
ping -s <IP address> 479
For TurboLinux:
ping -s <IP address> 480
IP address:
Set the same address entered at Step 2.
Windows Sample:
ping XXX.XXX.XXX.XXX -l 479
Note
z The -l entry is the alphabetic lower case "l" (not the number "1").
z The subnet mask and gateway addresses are set to 0.0.0.0.
This completes preparation for the protocol setting.
Setting the IP Address with the Printer Operation Panel
1
On the printer operation panel, press the Online button. The Online
lamp goes off.
2
Press the Setup button.
3
Press
Set Interface Æ Ext. Network Æ Set TCP/IP Æ Frame Type
or
to select the following items then press
.
Setting the Printer IP Address
2-7
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF W2200S and is the answer not in the manual?
Questions and answers