Adjusting Amount Of Media Feed; Media Feed Adjustment Procedure - Canon imagePROGRAF W6400 User Manual

Adjusting Amount of Media Feed

Adjusting Amount of Media Feed
Perform the procedure below to perform Adjust Band to
adjust the amount of line feed if you see white lines or dark
color lines in your printed images. As the band adjustment
pattern prints, the printer reads the results of the print and
automatically adjusts the settings of the amount of line feed for
the media currently loaded in the printer. Before you perform
the band adjustment, make sure a roll or cut sheet A3 (L) size
or wider is loaded in the printer.
Important
Before you adjust line feed, you must use the
operation panel to select media type for the paper
loaded for printing. If the value of the media type
selection does not match the paper loaded for printing,
you will not achieve good print results and the quality
of the printing will be poor.
Select Feed Priority > Band Joint in order to perform
Adjust Band.
Note
If you are using cut sheets, make sure at least one
sheet of unused A3 paper (not the blank sides of used
paper) or larger are set.
4- 42
There is no automatic adjustment for highly
transparent film. Execute Fine Tuning to perform the
adjustment with manual entry. (→ P.4-43)

Media Feed Adjustment Procedure

1
If the printer power is off, press the Power
button to switch the printer on.
Information Power
Data
Message
Cleaning
(3 sec.)
Stop/Eject
(1 sec.) Online
Within a short time, Online or Offline is displayed.
2
Press the Online button to display MAIN
MENU.
MAIN MENU
Head Cleaning
Cleaning
(3 sec.)
Stop/Eject
(1 sec.) Online
3
Press [ ] or [ ] to select Adjust Printer,
then press [ ].
MAIN MENU
Adjust Printer ↓
Offline
Menu
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index