Canon imagePROGRAF W6400 User Manual page 28

Function Menus
Menu Item
NetWare
NetWare
Frame Type
Print Service
AppleTalk
Ethernet Driver
Auto Detect
Comm. Mode
Ethernet Type
Spanning Tree
MAC Address
1- 25
Setting Values
Off*, On
Auto Detect, Ethernet 2, Ethernet
802.2*, Ethernet 802.3, Ethernet
SNAP
Bindary Pserver, RPrinter, NDS
Pserver*, NPrinter
On, Off*,
On*, Off
Half Duplex*, Full Duplex
10 Base-T*, 100 Base-TX
Not Use*, Use
Function
Sets the network interface for NetWare
protocol. After setting each TCP/IP item,
select Store Setting to save the settings and
enable them. This menu is displayed only
when the network interface is installed.
(→ P.5-35)
Determines whether NetWare protocol is
used.
Selects the frame type to use.
Selects the print service.
Determines whether AppleTalk protocol is
used. After setting each TCP/IP item, select
Store Setting to save the settings and enable
them. This menu is displayed only when the
network interface is installed. (→ P.5-30)
Sets the method of communication for the
network interface board. After setting each
TCP/IP item, select Store Setting to save
the settings and enable them. This menu is
displayed only when the network interface is
installed. (→ P.5-6)
Automatically recognizes the LAN
communication protocol. If set to Off, the
communication method or Ethernet type are
enabled.
Selects the LAN communication method.
Selects the LAN communication speed.
This selection determines whether the LAN
spanning tree signal is received.
Displays the MAC address of the network
interface board.
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index