Loading The Roll Media - Canon imagePROGRAF W6400 User Manual

Printing with Rolls

Loading the Roll Media

Follow this procedure to set a roll in the roll holder. First,
if there is a cut sheet or an ejected printed sheet on the
platen, remove it.
Important
When you are printing a banner or other long printout,
the printed media may touch the floor and become
dirty. Before starting the print job, cover the floor with a
clean cloth or some paper.
Note
Since the platen may be fouled with ink, clean inside
the upper cover before you switch to printing on a
large size. (→ P.4-11)
For more details about media that can be set in the roll
holder, please refer to
2- 27
"Media You Can Use" (→ P.2-2).
1
If there is roll media remaining in the printer,
push the release lever to the rear to open,
rotate the roll holder toward the rear to take
up the remaining paper, then remove the roll.
2
Lower the holder stopper release lever (a) to
release the lock, remove the holder stopper,
then remove the roll from the holder.
Important
Store unused roll media in its original package. Store
the package in a cool, dry location that is not exposed
to direct sunlight.
a
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index