Canon imagePROGRAF W6400 User Manual page 314

NetWare Settings (Windows)
NetWare Settings (Windows)
The chapter describes the setting methods and procedures
for connecting the printer to a NetWare network.
Procedures Required for a NetWare
Network
Here is a summary of the procedures required to set the
printer for use on a NetWare network.
The following procedure should be performed by the
network system administrator.
Installing the Network Interface
1
Board
First, install the optional network interface board.
2 Connecting the LAN Cable
Connect the LAN port to the HUB with the LAN cable.
3 Setting the Printer Frame Type
Perform the printer frame type setting. Use the
software below to setup communication between your
computer and the printer.
• GARO Device Setup Utility (Canon utility pro-
vided with the printer)
• Printer Operation Panel
5- 33
4 Setting Up a NetWare Print Service
Perform the NetWare printer service settings. Use
one of the utilities below to perform the settings on
the computer.
• NWADMIN or PCONSOLE (Novell software
application provided with NetWare)
5 Setting NetWare Protocol
Perform the printer protocol settings. You can use a
Web Browser from a computer on the network to
perform the network settings.
• Web Browser (Remote UI)
→
Quick Start
6 Setting the Computer for NetWare
Guide
Perform these settings on every computer to be used
with the printer.
→
P.5-5
→
P.5-34
TOP
Chapter 1
Basic Procedures
→
P.5-37
Chapter 2
Using a Variety of
Media
Chapter 3
→
P.5-40 Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
→
P.5-44
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index