Canon imagePROGRAF W6400 User Manual page 27

Function Menus
Menu Item
Color Adj.
Return Defaults
Color Adj. PM
Color Adj. PC
Color Adj. Y
Color Adj. M
Color Adj. C
Color Adj. K
Interface Setup
EOP Timer
TCP/IP
TCP/IP
IP Mode
Protocol
DHCP
BOOTP
RARP
IP Setting
IP Address
Subnet Mask
Default G/W
1- 24
Setting Values
Off*, On
1, 2*, 3
1, 2*, 3
1, 2*, 3
1, 2*, 3
1, 2*, 3
1, 2*, 3
10 sec., 30 sec., 1 min., 2 min.,
5 min., 10 min.*, 30 min., 60 min.
On
Manual*, Automatic
Off*, On
0.0.0.0* ~ 255.255.255.255
Function
This restores all color settings at once to 2,
the factory default setting.
You can adjust the density of PM 1, 2*, 3 Y,
M, C, K, PM, PC one by one and perform the
corrections.
The settings can be performed in the range 1
to 3 (the standard factory default setting is
2). Set to 1 for a light adjustment or set to 3
for a dark adjustment.
Sets the job timeout setting for the printer.
Sets the TCP/IP protocol for the network
interface. After setting each TCP/IP item,
select Store Setting to save the settings and
enable them. This menu is displayed only
when the network interface is installed.
(→ P.5-12)
The setting for TCP/IP protocol is locked On.
This setting cannot be changed.
This setting determines whether the IP
address is set automatically or entered
manually.
Sets the type of server when the printer is
set for automatic entry of the IP address.
Sets the printer network information if a fixed
IP address has been set.
Allows entry of the IP address assigned to
the printer, network subnet mask, and
default gateway.
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index