Canon imagePROGRAF W6400 User Manual page 262

Replacing the Cutter Blade
9
Install the cutter blade back into the carriage.
Note
To remove the protective cap from a new cutter blade,
turn the cap in the direction of the arrow. Also, you
must attach the removed cap to the used cutter blade
and discard the used blade in accordance with local
laws and regulations.
4- 31
10
Raise the upper cover stopper to release the
lock then close the upper cover.
Please Wait.. appears in the bottom line of the
display, the carriage moves, then the Reset Cut
Count message displays.
11
Once you have set the cutter position dial to
2 or 3 and pressed the Stop button and
replaced the cutter blade, press the OK
button.
Reset Cut Count
Press/OK Stop
The printer returns to the Online or Offline mode.
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index