Chapter - Canon imagePROGRAF W6400 User Manual

Replacing the Cutter Blade
6
Open the upper cover.
Important
Do not touch any areas other than those indicated.
Your hands could get dirty or this could damage the
printer.
If the cutter blade or the carriage is dirty, before you
perform the procedure to adjust the operation of the
cutter blade, wring out a damp, clean cloth and use it
to clean the cutter blade and the carriage.
7
Grasp the cutter blade (a) by the grips then
remove it from the carriage.
4- 30
Important
After removing the cutter blade, never touch the
cutting edge (b). This could cause personal injury.
8
Rotate the cutter position adjustment dial 1
notch in the direction shown.
If the dial is already at notch 3 replace the cutter
blade with a new one.
Note
The position adjustment dial has 3 positions that can
be adjusted; the blade can be used at three steps (1,
2, 3). The blade cannot be used with the dial returned
to a position.
Once you have set the cutter blade dial to position 3,
a
procure a new cutter blade for future replacement.

Chapter 1

Basic Procedures
Chapter 2
Using a Variety of
Media
b
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
TOP
Index