Canon imagePROGRAF W6400 User Manual page 291

TCP/IP Network Settings (Windows, Macintosh, UNIX)
Setting with the ARP/PING Command
To perform the setting with the ARP/PING command,
you need the MAC address of the printer. The MAC
address can be found printed on the status print or on
the seal attached to the expansion board, or on the
Information menu displayed on the printer operation
panel.
Checking the Printer MAC Address
Perform the procedure below to print a Status Print so
you can check the MAC address. Before printing, set a
roll of media larger than A3.
Note
The MAC address can be found printed on the nozzle
check pattern or the printhead adjustment pattern, or
on the printer operation panel: MAIN MENU >
Information > MAC Address.
1
If the printer power is off, press the Power
button to switch the printer on.
Data
Message
After a few moments, Online appears in the display.
5- 10
Information Power
Cleaning
(3 sec.)
Stop/Eject
(1 sec.) Online
Offline
Menu
2
Press the Online button to display MAIN
MENU.
MAIN MENU
Head Cleaning
Cleaning
(3 sec.)
Stop/Eject
(1 sec.) Online
3
Press [ ] or [ ] to select Test Print then
press [ ].
MAIN MENU
↓
Test Print
4
Press [ ] or [ ] to select Status Print,
then press OK button.
Test Print
Status Print
The information about the printer settings is printed.
After the nozzle check pattern has printed Online is
displayed in the operation panel and the printer is
ready to print.
TOP
Chapter 1
Basic Procedures
Chapter 2
Using a Variety of
Media
Chapter 3
Printing Methods for
Different Objectives
Chapter 4
Maintaining the
Printer
Chapter 5
Using the Printer in a
Network Environ-
ment
Chapter 6
Troubleshooting
Chapter 7
Operation of the
Function Menus
Contents
Index