Omron OMNUC G5 User Manual page 460

9-4 Setting the Mode
The absolute encoder reset function can be used only with systems that use an absolute encoder.
Parameter Initialization
This initializes the selected parameter.
1. Execute the initialization of the parameter.
operation
2. Returning to AUXILIARY FUNCTION mode display
9
operation
If alarm display No. 11 (power supply undervoltage), 36 (parameter error) or 37 (parameter
destruction) is displayed, the parameter cannot be initialized.
Front Panel Lock
This locks the front panel.
1. Displaying PARAMETER mode
operation
9-29
Precautions for Correct Use
Key
Display example
Key
Display example
Precautions for Correct Use
Key
Display example
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Explanation
Press the key to enter PARAMETER INITIALIZATION
mode.
Press and hold the key for 5 seconds or longer until
is displayed.
The bar indicator will increase.
The initialization of the selected parameter will start.
This indicates a normal completion.
will be displayed if the parameter could not be
initialized. Turn OFF the driver power supply and then execute
again.
Explanation
Press the key to return to AUXILIARY FUNCTION mode.
Explanation
Press the key to display MONITOR mode.
Press key to display PARAMETER SETTING mode.