Omron OMNUC G5 User Manual page 455

PARAMETER WRITE Mode
Set values changed in PARAMETER SETTING mode must be saved to EEPROM. To do so,
the following operation must be performed.
1. Saving changed set values
Key
operation
2. Returning to PARAMETER WRITE mode
Key
operation
Precautions for Correct Use
If a write error occurs, write the data again. If write errors continue to occur, there may be a fault
in the driver.
Do not turn OFF the power supply while writing to EEPROM. Incorrect data may be written if the
power supply is turned OFF. If the power supply is turned OFF, perform the settings again for all
parameters, and write the data again.
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Display example
Press the
Press the
Press and hold the
The bar indicator will increase.
Writing will start. (This display will appear only momentarily.)
This indicates a normal completion. In addition to this display,
either
displayed, writing has been completed normally, but some of the
changed parameters will be valid only after the power supply has
been turned OFF and ON again.Turn OFF the driver power
supply and then turn it ON again.
Write the data again.
Display example
Press the
9-4 Setting the Mode
Explanation
key to display PARAMETER WRITE mode.
key to enter PARAMETER WRITE mode.
key for 5 seconds or longer until
is displayed.
or may be displayed. If
will be displayed if there is a write error.
Explanation
key to return to PARAMETER WRITE mode.
is
9
9-24