Omron OMNUC G5 User Manual page 426

8-7 Special Parameters
Pn616
Absolute Interface Function Selection
Setting
range
Explanation of Set Values
value
Use this to set the function that outputs multi-rotation data as serial and 1-rotation data as initial
incremental pulse.
Pn617
Front Panel Parameter Write Selection
Setting
range
Explanation of Set Values
Set value
Set the EEPROM write conditions when the front panel parameter is changed.
8
Pn618
Power Supply ON Initialization Time
Setting
range
Set initialization time after power supply ON to the standard 1.5 seconds plus some.
Pn619
Encoder Phase-Z Setting
Setting
range
Finely adjust the encoder phase-Z width when the number of output pulses per motor rotation after
the division of pulse output is not an integer.
Pn620
External Scale Phase-Z Setting
Setting
range
Set the external scale phase-Z regeneration width with time.
You can output the phase-Z signal at least for the period of time that has been set if the phase-Z
signal width is too short for detection due to the travel distance from the external scale.
Pn621
Serial Absolute External Scale Phase-Z Setting
Setting
range
The external scale phase-Z output width can be extended.
When you perform the pulse output using an external scale as the output source under full closing
control that uses the serial absolute external scale, use this to set the intervals of phase-Z output
based on the number of external scale phase-A output pulses (before quadruple multiplier).
8-61
0 to 1 Unit
Set
0 Disabled
1 Enabled
0 to 1 Unit
0 EEPROM write not performed at the same time
1 EEPROM write performed at the same time
0 to 100 Unit
0 to 32,767 Unit
0 to 400 Unit
28
0 to 2 Unit
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Default
−
setting
Explanation
Default
−
setting
Explanation
Default
0.1 s
setting
Default
Pulse
setting
Default
μs
setting
Default
Pulse
setting
All
Power OFF
Yes
and ON
All
Power OFF
Yes
and ON
All
Power OFF
Yes
and ON
All
Power OFF
Yes
and ON
Full closing
Power OFF
Yes
and ON
Full closing
Power OFF
Yes
and ON