Omron OMNUC G5 User Manual page 408

8-5 Interface Monitor Setting Parameters
Pn435
Speed Conformity Detection Width
Setting
range
When speed command and motor speed are identical, speed conformity output signal is output.
This setting has a hysteresis of 10 r/min for detection.
Speed [r/min]
Pn435
Speed Conformity
Detection Range
Speed conformity
output
Pn436
Rotation Speed for Motor Rotation Detection
Setting
range
8
Speed reached output signal is output when the motor speed reaches the speed set as the
achieved speed.
This setting has a hysteresis of 10 r/min for detection.
Speed [r/min]
Pn436+10
Pn436−10
− (Pn436−10)
− (Pn436+10)
Speed reached
output
8-43
10 to 20,000 Unit
A speed command after the acceleration
Speed command
/deceleration processing
ON OFF
10 to 20,000 Unit
OFF ON
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Default
r/min
setting
Motor speed
Pn435
Speed Conformity Detection Range
ON
Default
r/min
setting
Motor speed
OFF ON
Speed
Power OFF
and ON
Pn435
Speed Conformity Detection Range
OFF
Speed
Power OFF
and ON
Time
−
Time
−