Initializing File Memory - Omron CS1D DUPLEX SYSTEM - 10-2009 Operation Manual

File Memory
Simple Backup Files
Note
2-5-3

Initializing File Memory

File type
Program files All user programs
Parameter files PLC Setup, registered I/O tables,
routing tables, CPU Bus Unit set-
tings, SYSMAC LINK link tables,
and Controller Link link tables
File type
Data files Words allocated to Special I/O
Units, CPU Bus Units, and Inner
Boards in the DM Area
CIO area
DM Area
EM area
Program files All user programs
Parameter files PLC Setup, registered I/O tables,
routing tables, CPU Bus Unit set-
tings, SYSMAC LINK link tables,
and Controller Link link tables
Unit/Board Data from specific Units or Boards BACKUP@@
backup files
1. Specify up to eight ASCII characters.
2. Always specify the name of files to be transferred automatically at startup
as AUTOEXEC or ATEXEC
3. The Units and Boards use the following file names.
Unit/Board
CPU Bus Units
Special I/O Units
Inner Boards
File memory
Memory Card
EM file memory
Note To delete all of the contents of a Memory Card, or to format the Memory Card,
use either a CX-Programmer or Programming Console with the CPU Unit. Do
not use a personal computer for this purpose.
Contents
Contents
.
@@
@@
I0 to IF 0 to F
20 to 6F 0 to 79
E1 ---
Initializing procedure
1. Install Memory Card into
CPU Unit.
2. Initialize the Memory Card
using a Programming Device
(including Programming Con-
sole).
1. Convert the part of the EM
Area from the specified bank
No. to the last bank No. to file
memory in the PLC Setup.
2. Initialize the EM file mem-
ory using a Programming
Device (excluding Program-
ming Console).
Section 2-5
File name
AUTOEXEC .OBJ
AUTOEXEC .STD
File name
BACKUP .IOM
BACKUPIO .IOR
BACKUPDM .IOM
BACKUPE@ (@: .IOM
EM bank No.)
BACKUP .OBJ
.STD
.PRM
(@@: Unit
address)
Unit No.
Data capacity after
initialization
Essentially the specific capac-
ity of the Memory Card
1 bank: Approx. 61 KB
13 banks: Approx. 825 KB
65