Wiring Cs-Series Basic I/O Units With Connectors - Omron CS1D DUPLEX SYSTEM - 10-2009 Operation Manual

Wiring Methods
Terminal Blocks
5-4-3

Wiring CS-series Basic I/O Units with Connectors

Note
Available Connectors
CS-series 32- and 64-point
I/O Units
176
The I/O Units are equipped with removable terminal blocks. The lead wires do
not have to be removed from the terminal block to remove it from an I/O Unit.
The terminal block can be removed by taking out the terminal block mounting
screws.
CS1-series Basic I/O Units
This section describes wiring CS-series Basic I/O Units with Connectors (32-,
64-, and 96-point Units). The user can combine a special connector with cable
or use a preassembled OMRON cable to connect a High-density I/O Unit to a
terminal block or I/O Terminal.
1. Be sure not to apply a voltage that exceeds the input voltage for Input Units
or the maximum switching capacity for Output Units.
2. When the power supply has positive and negative terminals, be sure to
wire them correctly.
3. Use reinforced insulation or double insulation on the DC power supply con-
nected to DC I/O Units when required by EC Directives (low voltage).
4. When connecting the connector to the I/O Unit, tighten the connector
screws to a torque of 0.2 N m.
5. Turn ON the power after checking the connector's wiring.
6. Do not pull the cable. Doing so will damage the cable.
7. Bending the cable too sharply can damage or break wiring in the cable.
Use the following connectors when assembling a connector and cable.
The following connectors are recommended for attachment to CS-series 32-
and 64-point I/O Units.
Connection
Solder-type
(included with Unit)
Crimp-type
Crimp-type
Note Solder-type connectors are included with each Unit.
Terminal block mounting screws
(black screws under cover)
Pins OMRON set
40 C500-CE404 Socket: FCN-361J040-AU
Connector bar: FCN-360C040-J2
40 C500-CE405 Socket: FCN-363J040
Connector bar: FCN-360C040-J2
Contacts: FCN-363J-AU
40 C500-CE403 FCN-367J040-AU/F
Section 5-4
Fujitsu parts