Omron CS1D DUPLEX SYSTEM - 10-2009 Operation Manual page 179

Basic Procedures
1,2,3...
1,2,3...
1. Set the device type in the CX-Programmer as shown in the following table.
System
Duplex CPU Systems
Single CPU Systems
2. Create the I/O tables offline.
a) Double-click IO Table on the project tree in the main window. The I/O
Table Window will be displayed.
b) Select PLC - PLC Information - I/O Table, and then double-click the
Rack to be edited. The slots for that Rack will be displayed.
c) Right-click the slots to be edited and select the desired Units from the
pull-down menu.
3. Select Options and then Transfer to PLC to transfer the I/O tables to the
active CPU Unit. The I/O tables will automatically be copied to the standby
CPU Unit as well.
Note The first word allocated to each Rack can be set in the PLC Setup under the
Options menu.
Using a Programming Console
Use the following procedure to register the I/O table with a Programming Con-
sole.
1. Install all of the Units in the PLC.
Install the Units
2. Connect the Programming Console to the peripheral port. (See note.)
(It can be connected with the power ON.)
Note With a Duplex CPU System, connect the Programming Console to
the active CPU Unit.
3. Register the I/O tables.
FUN
CX-Programmer
version 3.@
CS1H-H
Not supported
LEFT CPU
RIGHT CPU
DPL SW
ON
INIT.
SW
ON
DUPLEX DUPLEX
000000 CT00
CLR
000000 I/O TBL ?
CH
SHIFT
*DM
000000 I/O TBL
CHG
WRIT
000000 I/O TBL
WRIT
Section 4-2
CX-Programmer
version 4 or higher
CS1H-H or CS1D-H
CS1D-S
Programming Console
PRO27 PR O27
PR PROGRAMMING CONSOLE OGRAMMING CONSOLE
MONITOR
RUN PROGRAM
FUN SFT NOT
AND OR TR LR HR
CNT
LD OUT TIM DM CH
7 8 9 EXT
E F 5 6
4
B 1 C 2 D 3
A 0
EAR MIC
????
????
Password (9713)
143