Omron CS1D DUPLEX SYSTEM - 10-2009 Operation Manual page 245

Specific PLC Setup Settings
CPU Execution Mode Setting (Sync/Async Comms) (Single CPU Systems Only)
Execution Mode
Address in
Programming
Console
Word Bit(s)
219 00 to 15 00
01
02
Default: 00
Note
Set Time to All Events (Fixed Peripheral Servicing Time)
Enable Fixed Servicing Time
Address in
Programming
Console
Word Bit(s)
218 15 0: Default*
1: Bits 0 to 7
Default: 0
Fixed Servicing Time
Address in
Programming
Console
Word Bit(s)
218 0 to 7 00 to FF hex:
0.0 to 25.5 ms
(0.1-ms units)
Default: 00 hex
Settings
00: Not specified (disable parallel process-
ing)
01: Synchronous (Synchronous Memory
Access
02: Asynchronous (Asynchronous Memory
Access)
1. This setting cannot be used with Duplex CPU Systems. The default setting
will be used even if the setting is changed.
2. A PLC Setup error will occur if any non-specified value is set.
Settings
Set to 1 to enable the fixed peripheral ser-
vicing time in bits 0 to 7.
*Default: 4% of the cycle time
Settings
Set the peripheral servicing time.
This setting is valid only when bit 15 of 218
is set to 1.
Function
Function
Function
Section 6-2
Related New set-
flags and ting's effec-
words tiveness
--- Takes effect
at the start of
operation
(Can't be
changed dur-
ing opera-
tion.)
Related New set-
flags and ting's effec-
words tiveness
--- Takes effect
at the start of
operation
(Can't be
changed dur-
ing opera-
tion.)
Related New set-
flags and ting's effec-
words tiveness
--- Takes effect
at the start of
operation
(Can't be
changed dur-
ing opera-
tion.)
209