Table of Contents
Advertisement
Specific PLC Setup Settings
Memory Allocation Settings
EM File Setting Enabled
Address in
Programming
Console
Word
Bit(s)
136
7
0: None
1: EM File Memory
Enabled
Default: 0
EM Start File No. (Starting Memory Starting Bank)
Address in
Programming
Console
Word
Bit(s)
136
0 to 3
0 to C hex (0 to 12)
Default: 0
Background Execution Settings (Single CPU Systems Only)
Table Data Process Instructions
Address in
Programming
Console
Word
Bit(s)
198
15
0: Not executed in
background
1: Executed in back-
ground
Default: 0
String Data Process Instructions
Address in
Programming
Console
Word
Bit(s)
198
14
0: Not executed in
background
1: Executed in back-
ground
Default: 0
Settings
This setting determines whether part of the
EM Area will be used for file memory.
Settings
If bit 7 (above) is set to 1, the setting here
specifies the EM bank where file memory
begins. The specified EM bank and all sub-
sequent banks will be used as file memory.
This setting will be disabled if bit 7 is set to
0.
Settings
This setting determines if Table Data
Instructions will be processed over multiple
cycle times (i.e., processed in the back-
ground).
Note This setting cannot be used with Duplex CPU Systems.
Settings
This setting determines if Text String Data
Instructions will be processed over multiple
cycle times (i.e., processed in the back-
ground).
Note This setting cannot be used with Duplex CPU Systems.
Function
Function
Function
Function
Section 6-2
Related
New set-
flags and
ting's effec-
words
tiveness
---
After initial-
ization from
Program-
ming Device
or via FINS
command.
Related
New set-
flags and
ting's effec-
words
tiveness
A344 (EM
After initial-
File Memory
ization from
Starting
Program-
Bank)
ming Device
or via FINS
command.
Related
New set-
flags and
ting's effec-
words
tiveness
---
Start of oper-
ation
Related
New set-
flags and
ting's effec-
words
tiveness
---
Start of oper-
ation
195
Advertisement
Chapters
Table of Contents
Troubleshooting
