Omron CS1D DUPLEX SYSTEM - 10-2009 Operation Manual page 253

Specific PLC Setup Settings
EM Division Transmission
Address in
Programming
Console
Word Bit(s)
96 14 0:Transfer the EM
Area together for
duplex operation
1: Transfer the EM
area over more than
one cycle
Default: 0
Transfer Parameter Area of Inner Board
Address in
Programming
Console
Word Bit(s)
96 11 0: Transfer Inner
Board Parameter
Area
1: Do not transfer
Default: 0
Transfer Variable Area of Inner Board
Address in
Programming
Console
Word Bit(s)
96 10 0: Transfer Inner
Board Variable Area
1: Do not transfer
Default: 0
Settings
This setting determines the method that will
be used to transfer the EM Area all at the
same time or in pieces over more than one
cycle (including when the standby CPU Unit
is replaced).
This setting can be used to reduce the cycle
time by transferring the data in pieces when-
ever the EM Area is not used by the pro-
gram, for data links, etc.
Settings
This setting determines if the parameter
area is transferred between Duplex Inner
Boards.
Note As of October 2006, there are no Inner Boards to which this setting applies.
Use the default setting.
Settings
This setting determines if the variable area
is transferred between Duplex Inner Boards.
Note As of October 2006, there are no Inner Boards to which this setting applies.
Use the default setting.
Function
Function
Function
Section 6-2
Related New set-
flags and ting's effec-
words tiveness
--- At startup
and at start of
operation
Related New set-
flags and ting's effec-
words tiveness
--- At startup
and at start of
operation
Related New set-
flags and ting's effec-
words tiveness
--- At startup
and at start of
operation
217