Internal 16-Pin Auxiliary I/O Connector (Top) And 10-Pin Auxiliary I/O Connector (Bottom) - Matrox Solios eV-CL Installation And Hardware Reference

90 Appendix B: Technical information
Warning
To build your own cable, you can purchase the following parts:
M a n u f a c t u r e r :
C o n n e c t o r :
B a c k s h e l l :
These parts can be purchased from third parties such as Digi-Key Corporation
(www.digikey.com).
Internal 16-pin auxiliary I/O connector (top) and 10-pin auxiliary
I/O connector (bottom)
The internal 16-pin auxiliary I/O connector (top) and the internal 10-pin
auxiliary I/O connector (bottom) on the Matrox Solios eV-CLB and Matrox Solios
eV-CLF boards are 0.1" spacing, 16-pin and 10-pin male connectors, respectively.
You can use one of the connectors to transmit/receive auxiliary signals for one of
the acquisition paths. By default, the auxiliary I/O connectors carry the auxiliary
signals for acquisition path 1; if a jumper is installed on the 2-pin I/O acquisition
path connector, the auxiliary I/O connectors carry the auxiliary signals for
acquisition path 0. The connectors are located close to the top edge of the board,
making the auxiliary signals accessible from inside the computer enclosure.
❖ The internal 16-signal auxiliary I/O connector and the internal 10-signal auxiliary
I/O connector are mutually exclusive. You can use one or the other, but not both.
M a t i n g i n f o r m a t i o n f o r D B - 1 5
N o r C o m p , I n c .
1 8 0 - 0 1 5 - 2 0 3 L 0 0 1
9 7 0 - 0 1 5 - 0 1 0 - 0 1 1
M a t i n g i n f o r m a t i o n f o r D B - 9
N o r C o m p , I n c .
1 7 2 - E 0 9 - 1 0 2 - 0 3 1
9 7 0 - 0 0 9 - 0 1 0 - 0 1 1