Table of Contents
Advertisement
Configure your system BIOS settings
9. Install the fourth card in the same way.
10. Flip the entire unit over and insert the remaining mounting screws
through the top of the Movie-2 bus. Avoid putting too much stress
on the Movie-2 bus.
11. Carefully install the entire card-bus unit in the intended host
computer making sure all cards are firmly seated in their slots. Secure
each card's back plate to the computer.
The first time you restart your computer, you will have to reconfigure
your system's BIOS settings. The settings for each DigiSuite card are
different, so each individual installation reference manual contains a
section entitled "System BIOS settings." Refer to this section for each
card you've installed in your system.
Once you've completed this reconfiguration, you can proceed with the
instructions in the next chapter.
Configure your system BIOS settings
23
Advertisement
Table of Contents
