Table of Contents
Advertisement
Installing memory
To install a memory module in the Matrox 4Sight X unit:
1. Ensure that the clips at each end of the SO-DIMM slot are spread.
2. Position the module over the SO-DIMM slot, such that the notch along the
module's bottom edge is aligned with the notch of the SO-DIMM slot.
3. Gently insert the bottom edge of the module into the slot.
4. Carefully close the two clips over the side notches of the module.
Removing memory
To remove a memory module from the Matrox 4Sight X unit:
1. Spread the clips at each end of the SO-DIMM slot.
2. Lift the module out of the slot.
Adjusting the new memory settings
If the Matrox Imaging Library (MIL) or one of its derivatives is installed on the
unit, you must adjust the unit's new memory settings using MilConfig (the MIL
Configuration utility). Refer to the MIL User Guide for more information on
using this utility.
Installing or removing RAM
77
Advertisement
Table of Contents
