ENOM00075-0
3. Remote control lever friction
EP, EPT type
ENOW00074-1C
WARNING
Do not over tighten the remote control
throttle friction adjustment screw or it
could result in difficult handling of the out-
board motor, resulting in the loss of control
causing an accident and could lead to severe
injury.
To adjust the friction of the remote con-
trol lever, turn the throttle friction
adjustment screw on the front of the
remote control . Turn c lock wise to
increase the friction and counter-clock-
wise to decrease it.
Side mount type
2
1
1. Throttle friction adjustment screw
2. Decrease
3. Increase
3
ENOF00078-2
ENOM00076-0
4. Trim tab adjustment
ENOW00076-1
WARNING
Be sure that the outboard motor is
secured to transom or service stand, or
accidental drop or fall of outboard motor
could lead to severe personal injury.
Be sure to lock the outboard motor in the
tilt up position, or accidental fall of out-
board motor could lead to severe per-
sonal injury.
Do not go under outboard motor in the tilt
up position and locked, or accidental fall
of outboard motor could lead to severe
personal injury.
ENOW00075-1
WARNING
Inappropriate adjustment of trim tab could
cause steering difficulty. After installing or
readjusting trim tab, check if steering load is
even.
If straight-line cruising can not be
achieved, adjust the trim tab located
under the anti-ventilation plate.
If the boat veers toward the left direct
the trim tab towards A (left from rear
of boat).
If the boat veers toward the right
direct the trim tab towards B (right
from rear of boat).
57
ADJUSTMENT
9