Table of Contents
Advertisement
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
6.3.2 Positioning control operation program
The various programs that configure the "positioning control operation program" are
shown below. When creating the program, refer to the explanation of each program
and section "6.4 Positioning program examples", and create an operation program that
matches the positioning system. (Numbers are assigned to the following programs.
Configuring the program in the order of these numbers is recommended.)
Set using the AD75
software package
No.5
No.7
PLC READY signal [Y1D] ON program
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Start of program creation
Set using sequence program
(TO command)
Parameter and
data are...
No.1
No.2
No.3
Not carried out
Zero point return is...
No.4
Zero point return request OFF program
Carried out
External start function valid
Refer to 6.5.1
setting program
Set
Clock data is ...
No.6
Not set
* Required
Continued on next page
Parameter setting program
* When not carrying out "zero point return
control", the zero point return parameters
do not need to be set.
Positioning data setting program
Positioning start information
setting program
Clock data setting program
6 - 9
MELSEC-A
Parameter and data
setting program
Initialization program
Refer to section 6.5.1
Refer to section 13.5
Advertisement
Table of Contents
Troubleshooting
