4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
4.3.3 Connecting the connector
The AD75 is connected to the drive unit or peripheral device with the connector. Use
the following procedure to connect.
(1) Connecting
(2) Removing
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
(a) Confirm that all phases of the AD75 main unit's power are shut
off externally.
* If not shut off, shut off all phases of the power externally.
(b) Confirm the module connector connection state and connector
shape, and match the engagement orientation.
(c) Press the connector straight into the module until a "click" is
heard.
(a) Confirm that all phases of the AD75 main unit's power are shut
off externally.
* If not shut off, shut off all phases of the power externally.
(b) Press in the latches on both sides of the connector, and pull
the connector straight off.
4 - 17
MELSEC-A