Override Function - Mitsubishi Electric A1SD75P1-S3 User Manual

12 CONTROL AUXILIARY FUNCTIONS

12.5.2 Override function

The override function changes the command speed by a designated percentage (1 to
300%) for all control to be executed.
The speed can be changed by setting the percentage (%) by which the speed is
changed in " Cd.18 Positioning operation speed override".
(1) Control details
Da. 7 Command speed
Cd. 18 Positioning operation
speed override value
Md. 31 Feedrate
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
(1) Control details
(2) Precautions during control
(3) Setting the override function
The following shows that operation of the override function.
1) A value changed by the override function is monitored by " Md.31
Feedrate".
2) If " Cd.18 Positioning operation speed override" is set to 100%, the speed
will not change.
3) If " Cd.18 Positioning operation speed override" is set a value less than
100%, control will be carried out at speed unit "1" at the time " Md.31
Feedrate" becomes a value of "1" or less.
4) If there is not enough remaining distance to change the speed when the
speed is changed during the position control of speed/position changeover
control, the operation will be carried out at the speed that could be changed.
5) If the speed changed by the "override function" is greater than the " Pr.7
Speed limit value", a warning "speed limit value over" (warning code: 501)
will occur and the speed will be controlled at the " Pr.7 Speed limit value".
The " Md.49 In speed limit flag" will turn ON.
50
50 150
100 1
50 1 25 75
V
Fig. 12.27 Override function operation
100
50
Not affected by the override value
during deceleration
12 - 42
MELSEC-A
200
75
Not enough remaining
distance could be secured
so operation is carried out
at an increased speed.
t