Jog Operation Example - Mitsubishi Electric A1SD75P1-S3 User Manual

11 MANUAL CONTROL

11.2.5 JOG operation example

PLC READY signal
AD75 READY signal
Forward run JOG start signal
[Y16, Y18, Y1A]
Axis stop signal
[Y13, Y14, Y1C]
BUSY signal [X4, X5, X6] OFF
Fig. 11.6 Operation when the stop signal is turned ON during JOG operation
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
When the "stop signal" is turned ON during JOG operation
When the "stop signal" is turned ON during JOG operation, the JOG operation will
stop by the "deceleration stop" method.
JOG start signals will be ignored while the stop signal is ON.
The operation can be started by turning the stop signal OFF, and turning the JOG
start signal from OFF to ON again.
ON
[Y1D]
OFF
ON
[X0]
OFF
ON
OFF
OFF
ON
POINT
The AD75 will not receive a "JOG start signal" while the "stop signal" is ON.
A JOG start signal OFF → ON
while the stop signal is ON will be ignored.
ON
11 - 13
MELSEC-A