Mitsubishi Electric A1SD75P1-S3 User Manual page 580

APPENDICES
RESOLVER
This device detects the angle by resolving the
two voltages of the analog input. Also called a
2-phase synchro. For a 1-phase voltage input,
the axis rotation angle is converted into a
perpendicular 2-phase voltage (analog
voltage) and output.
Movement distance
for one resolver rotation
Toothed gear
Position detection value
Resolver
Motor
(addresses 0 to 4095, converted to digital)
RLS SIGNAL (Reverse Limit Switch Signal)
This is the input signal XnC that notifies the
user that the lower limit switch (b contact
configuration, normally ON) outside the
movement range at which positioning control is
carried out was activated.
The positioning operation stops when the
external RLS signal (b contact) turns OFF
(non-continuity status).
ROTARY TABLE
A round table on which the workpiece is
placed. Positioning control is carried out while
rotating the workpiece in a 360 ° range.
S-PATTERN
ACCELERATION/DECELERATION
In this pattern, the acceleration and
deceleration follow a sine curve, and the
movement is smooth. The S-pattern proportion
can be set from 1 to 100%.
Acceleration
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Deceleration
Appendix - 40
SERVO AMPLIFIER
Refer to the term "DRIVE UNIT".
SERVO LOCK
In positioning using a servomotor, stepping
motor, etc., working power is required to hold
the machine at the stop position.
(The position will be lost if the machine is
moved by external power.)
This kind of state is called servo lock or servo
lock torque.
Table
SERVO ON
The servo module will not operate if the drive
unit is in a normal state and this servo ON
signal is OFF.
READY
AD75
SERVOMOTOR
A motor that rotates true to the command.
Servomotors are highly responsive, and can
carry out frequent high-speed and high-
accuracy starts and stops.
DC and AC types are available, as well as
large-capacity motors. A pulse encoder
accessory for speed detection is common, and
feedback control is often carried out.
MELSEC-A
M
Motor holds the position
at the stop position.
Drive
Servo ON
unit
Motor PLG Encoder