Mitsubishi Electric A1SD75P1-S3 User Manual page 533

14 TROUBLESHOOTING
Relevant buffer memory address
Axis 1 Axis 2 Axis 3
74 224 374
75 225 375
76 226 376
77 227 377
78 228 378
86 236 386
80 230 380
81 231 381
82 232 382
83 233 383
88 238 388
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting range
(Setting given in sequence program)
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
(In standard mode)
1 to 1000000 [pulse/s]
1 to 600000000 [mm/min, etc.]
(In stepping motor mode)
1 to 62500 [pulse/s]
1 to 37500000 [mm/min, etc.]
0, 1
1 to 300
(In standard mode)
0 to 2147483647
(In stepping motor mode)
0 to 134217727
0, 1, 2 ,3
0, 1, 2 ,3
0, 1
14 - 29
Remedy
Change the setting to within the setting range and turn
OFF then ON the PLC READY signal (Y1D).
• Write the flash ROM again.
• If the same error persists, replace the module.
MELSEC-A