General Specifications - Mitsubishi Electric A1SD75P1-S3 User Manual

3 SPECIFICATIONS AND FUNCTIONS

3.1 General specifications

The general specifications of the AD75 are given below.
Item
Working ambient temperature
Storage ambient temperature
Working ambient humidity
Storage ambient humidity
Vibration resistance
Impact resistance
Working atmosphere
3
Working altitude *
Installation place
1
Overvoltage category *
2
Degree of contamination *
1
* Indicates to which power distribution section, from the public power distribution network to the in-plant machine
device, the device is assumed to be connected to.
Category II applies to a device fed power from a fixed facility.
The withstand surge voltage level for a device with a rating up to 300V is 2500V.
2
* Exponential indicating the degree of conductive matter generated in the environment where device is used.
In the degree of contamination level 2, only non-conductive contaminants are generated. However, temporary
conductivity could occur due to rare condensation.
3
* Do not use or store the PLC in the environment where the pressure is higher than the atmospheric pressure at sea
level. Otherwise, malfunction may result. To use the PLC in high-pressure environment, contact your nearest
Mitsubishi representative.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
10 to 90% RH, with no dew condensation
10 to 90% RH, with no dew condensation
For
JIS B 3502,
intermittent
IEC 61131-2
vibration
compliant
For
continuous
vibration
JIS B 3502, IEC 61131-2 compliant (147m/s
and Z directions)
3 - 2
Specifications
0 to 55 ° C
-20 to 75 ° C
Frequency Acceleration
10 to 57Hz –
2
57 to 150Hz 9.8m/s
10 to 57Hz –
2
4.9m/s
57 to 150Hz
2
, three times each in X, Y
Must be no corrosive gases
2,000m or less
Within control panel
II or less
2 or less
MELSEC-A
Amplitude No. of sweeps
0.075mm
10 times each in
X, Y and Z
–
directions
0.035mm
(During 80
minutes)
–