Table of Contents
Advertisement
The screen transitions to the Sample Loading screen after loading the Sample
Rack and the Barcode Correction window opens.
2. Do not close the Sample Bay Door. Follow the instructions on the screen entitled,
if EQC is unlabeled:
a. From the Barcodes Correction screen, select OK.
The Barcodes Correction screen closes.
b. Select the message in the Status column for the EQC.
c. Select Assign EQC.
The EQC Selection window opens.
d. Select the EQC Name field.
The External Quality Control Name window opens.
e. Select the desired EQC from the list of available names and then select OK.
The EQC Selection window updates with the chosen EQC information.
f. Select Accept to save the selection made for the EQC.
3. Repeat Step 2 for any additional unlabeled EQCs.
4. Continue with correcting any unreadable specimen barcodes or reflex testing
assignment on the Sample Loading screen, as necessary.
5. Select Accept Rack when finished updating the test configuration for the Sample
Rack.
Selecting Assays During EQC Loading
To select assay type(s) for an EQC that's configured for multiple assays:
1. Load the EQC into the Sample Bay following the instructions in the Load
Samples section (see Load Samples on page 113).
The screen transitions to the Sample Rack Loading screen.
2. Select the message in the Status column for the EQC.
3. Select the Select EQC Assays button.
The EQC Assay Selection window opens.
4. Select Add.
5. Select the desired assay type(s) from the list.
6. Select OK when completed with assay selection.
7. Select Accept to save the selection made for the EQC.
8. Select Accept Rack when finished updating the test configuration for the Sample
Rack.
Adding Manufacturer Control/Calibrator Overrides
To create a manufacturer control/calibrator override:
®
Panther System
Operator's Manual
AW-17791-001 Rev. 002 (EN)
System Administration
249
Advertisement
Table of Contents
