Table of Contents
Advertisement
Table 95. User Interface Options (Continued)
Option
Non-IVD Assay
Mode
Enable Automatic Log Off
To enable automatic logoff:
1. From the expanded User Interface menu on the System Configuration screen, check
the Enable Automatic Log Off cell.
2. Select the Automatic Log Off Inactivity Period (minutes) field.
A keypad window opens.
3. From the keypad window, select the desired inactivity period (between five (5) and 60
minutes) for the system to wait before logging off the current operator.
4. Select OK when finished.
Threshold Management
Use the option available in the Threshold Management expansion menu to configure the
waste settings as needed.
If this threshold is met while in the Setup or Ready states, the system provides notification
and requires acknowledgment before allowing more samples to be loaded. Additional
samples can be loaded until the Waste test count reaches zero (0).
Select and configure the following option within the menu:
Table 96. Threshold Management Options
Option
Enable
Waste
Threshold
Waste Threshold
To set the Waste Threshold:
1. From the expanded Threshold Management menu on the System Configuration
screen, check the Enable Waste Threshold cell.
®
Panther System
Operator's Manual
AW-17791-001 Rev. 002 (EN)
Description
Check this cell to turn off IVD mode and turn on Non-IVD
mode, which allows the user to run assays that are Non-IVD
(e.g. IUO, PEO). The software must be restarted before the
selected configuration setting is enabled in the software.
Description
Select this field to set the lower limit alarm threshold (between
0 to 200) for the Waste inventory. Set the number for the
remaining tests that will trigger a system alarm. The system
will alert the operator when this threshold has been met. The
software must be restarted before the selected configuration
setting is enabled in the software.
System Administration
220
Advertisement
Table of Contents
