Results Information
The table on the Results screen displays the following information for each test
order.
Sample ID—Identification for the sample from the barcode, manual entry, or auto-
l
generated sample IDs.
Completion Time—The completion time for the result.
l
Assay—Assay associated with test result.
l
Status—Sample status (see Monitoring Loaded Specimen Status on page 144).
l
Result Flags—System-generated codes applied to the test (see Results
l
Processing Flags on page 283).
Result 1–6—RLU and analyte result data is displayed in these columns. Test
l
results provided in these columns are dependent upon Assay type.
Sample Type—Sample category (e.g. specimen, calibrator, control, external
l
quality control).
LIS Result Status—Data status in regards to LIS transmission.
l
Verified—Verified data status (True or False).
l
Rack and Pos—Sample Rack ID number and tube position within the rack from
l
where the sample was pipetted.
Worklist ID—ID number associated with all samples that were tested against the
l
same set of controls/calibrators. The worklist ID follows the naming convention:
XXXXX[Serial Number]- YYYYMMDD[Date a ]-XX[2digitSeqNum b ]
®
Panther System
Operator's Manual
AW-17791-001 Rev. 002 (EN)
Figure 77. Results Screen—Expanded (Example)
System Operation
151